Predator Bio Engineer Concept
Added 2020-06-03 20:05:05 +0000 UTCI've supplied a couple of extra pieces than usual, the pipes are a tough print so there is some pre-plated presupported full sets to make things a little easier, just use a low infill setting and the supports wont take much at all. There is also an optional cut P1 which is not in the manual above (just an additonal 2 part split)
Chin support added in case you dont want to wall mount it as it would fall forward otherwise. Overall should not be too difficult to print!
enjoy :)
*Files are located on the member depot under Movie helmets, Predator.
Comments
Do the main pieces require supports?
Steve Mcqueen
2020-11-13 07:37:47 +0000 UTCis there and uncut version at all?
Michael Wigan
2020-06-24 23:21:49 +0000 UTC
