Bat-Lamp 1:1 Scale
Added 2020-04-18 17:18:47 +0000 UTCUPDATE: FIXED LARGE UNCUT FOREARM P2/3/4
(if you are printing the 4 piece cut version of the arm, this does not matter for you)
Not too difficult a build, just a few parts to knock out. Assembly manual included.
Large parts like the base have optional cuts (marked A,B,C,D both on the file and on the model itself )
LED's/Lights are really up to you. I've set the small 12 x holes around the edge for 5mm leds, feel free to drill them out larger. The 4 lamps in the surrounds, its up to you again, but there is room for at least 15x 5mm leds in each lamp. The middle diffuser is large enough to accomodate a LED light bulb or similar (Main middle Diffuser P18 is 4mm thick, OD 108mm, ID 100mm)
Enjoy :)
Comments
I plan on wiring up neo pixel ring light with the spots cluster to a Arduino mini , when i get i get the lights built and tested ill post my solution But i am going to be at least 3 weeks before i get onto this project - so here is my recommendations to start https://www.instructables.com/id/A-Very-Quick-NeoPixel-16-Ring-Test-With-Arduino-Un/ LED light cluster https://www.instructables.com/id/3-dimensional-Star-Cluster-Acrylic-LED-light-sc/
Chris White
2020-04-20 04:35:55 +0000 UTCoof i want to try this but i am lacking knowledge in the wiring department! and there is too much info on the internet, can't seem to make heads or tails of any of it. anyone can recommend where to get the electronic parts to do this?
Nuha Jalal
2020-04-20 02:09:41 +0000 UTCThe baby yoda from the Speederbike can be used in the empty maglev pod I think, or one of the other 10 baby yoda's, ive not done one specifically to fit into that pod yet
Geoffro / Hex3D
2020-04-20 02:05:23 +0000 UTCVery nice! BTW, did the maglev version of the baby yoda get completed? I'm having trouble finding all the parts. I've done the crib and the base, but can't find the file for the baby to go in the crib.
Peter Richards
2020-04-20 01:59:56 +0000 UTC
