Ashfall City - Released!
Added 2023-05-20 17:20:07 +0000 UTCHello friends!
the time has arrived! This month's set has just been released! There are two ground floor versions - with and without rubble.
Looking at the current poll standings, it appears we may have a mammoth model next month, so if I could take my leave as this month is now done... There's a dark bastion that needs modelling!
Thank you for all your support this month!
Pinyo
Comments
Also just discovered that Timber_barricade_2 and Timber_Exit_barricade_1 are the exact same model with different orientation. The barricade on the left entrance door in the render is missing.
Beholder.Madness
2023-06-18 17:19:11 +0000 UTCJust printed the theater, and I have a few issues. First, on the cut versions, the tabs that stick out are impossible to print without supports. a pyramid shape instead of a long triangle would work much better. One of your ground floor cuts slices through the edge of a post. But my biggest problem, the theater entrance doors will not fit in place with the rubble piles on one side of each entrance. There either needs to be a slot for the door to fit into, or a door cut at the bottom over the rubble. I'm going to just cut the door, but I thought you'd want to know. As for the rubble piles, there are a few small stones on the edge of the plies that, while looking realistic, are barely attached to the larger pile and break off way too easily. These are not complaints, I really love the model. TIP for everyone: There are many flat overhangs on the model, so printing with supports will give much better results. I used normal supports, everywhere, with a support overhang angle of 85.
Beholder.Madness
2023-06-18 14:09:30 +0000 UTC
